12
Super X11DPT-PS User's Manual
Motherboard Features
CPU
• Dual Intel® Xeon 81XX/61XX/51XX/41XX/31XX series processors (Socket P0); each processor supports Socket P0 UPI
10.4 GT/s
Note: Both CPUs need to be installed for full access to the PCI-E slots, DIMM slots, and onboard controllers. Refer
to the block diagram to determine which slots or devices may be affected.
Memory
• Integrated memory controller supports up to 2TB of Load Reduced DIMM (LRDIMM), Registered DIMM (RDIMM), Non-
Volatile DIMM (NV-DIMM) DDR4 (288-pin) ECC 2666/2400/2133/1866/1600/1333 MHz modules in 16 slots
DIMM Size
• Up to 128GB at 1.2V
Note 1: Memory speed support depends on the processors used in the system.
Note 2: For the latest CPU/memory updates, please refer to our website at http://www.supermicro.com/products/
motherboard.
Chipset
• Intel C621
Expansion Slots
• One (1) PCI-Express 3.0 x8 slot supported by CPU1 (SXB1)
• One (1) PCI-Express 3.0 x16 slot supported by CPU2 (SXB2)
• One (1) PCI-Express 3.0 x16 slot supported by CPU1 (SXB3_1)
• One (1) PCI-Express 3.0 x8 slot supported by CPU2 (SXB3_2)
• One (1) PCI-E 3.0 x16 slot supported by CPU2 (SXB4)
BaseBoard Management Controller (BMC)
• ASpeed AST 2500 Baseboard Controller (BMC) supports IPMI 2.0
• One (1) IPMI dedicated LAN located on the rear IO backpanel
Graphics
• Graphics controller via AST 2500 BMC
I/O Devices
• Serial (COM) Port • One (1) Fast UART 16550 port on the I/O back panel
• SATA 3.0
• Six (6) SATA 3.0 ports supported by PCH on SXB1 (S-SATA 0-5 on SXB1)
• Four (4) SATA 3.0 ports supported by PCH on SXB2 (I-SATA 0-3 on SXB2)
• Two (2) SATA 3.0 ports with power-pins built-in, w/support of Supermicro
SuperDOM (I-SATA4/S-IATA5)
• RAID (PCH) • RAID 0, 1, 10
Peripheral Devices
• Two (2) USB 3.0 ports on the rear I/O panel (USB 0/1)
Motherboard Features
To Next Page
Loading...
