Supermicro X11SSW-F - Page 90

X11SSW-F User Manual
90
Serial Port 2 Change Settings
This feature species the base I/O port address and the Interrupt Request address of a serial
port specied by the user. Select Auto to allow the BIOS to automatically assign the base
I/O and IRQ address. The options for Serial Port 2 are Use Automatic Settings, (IO=2F8h;
IRQ=3; DMA), (IO=3F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; DMA), (IO=2F8h; IRQ=3, 4, 5, 6,
7, 9, 10, 11, 12; DMA), (IO=3E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; DMA), and (IO=2E8h;
IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; DMA).
Serial Port 2 Attribute (Available for Serial Port 2 only)
Select SOL to use COM Port 2 as a Serial_Over_LAN (SOL) port for console redirection.
The options are SOL and COM.
Intel Server Platform Services
The following Intel Server Platform Services information will display:
• ME BIOS Interface Version
• SPS Version
• ME FW Status Value
• ME FW State
• ME FW Operation State
• ME FW Error Code
• ME NM FW Status Value
• BIOS Booting Mode
• Cores Disabled
• ME FW SKU Information
• End-of-Post Status
Serial Port Console Redirection
COM1 Console Redirection
Select Enabled to enable console redirection support for a serial port specied by the user.
The options are Enabled and Disabled.
*If the item above set to Enabled, the following items will become available for user's
conguration: