12
X11SSZ-TLN4F/QF/F User's Manual
Note: Table is continued on the next page.
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal)
JI
2
C1/JI
2
C2 SMB to PCI-E Slots Enable/Disable Pins 2-3 (Disabled)
JPAC1 Front Panel Audio Enable Pins 1-2 (Enabled)
JPB1 BMC Enabled Pins 1-2 (Enabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPL1/JPL2 LAN1/2 Enable/Disable Pins 1-2 (Enabled)
JPL3 (TLN4F only) LAN3/4 Enable/Disable Pins 1-2 (Enabled)
JPME2 Manufacturing Mode Pins 1-2 (Normal)
JWD1 Watch Dog Pins 1-2 (Reset)
LED Description Status
LED1 Unit ID LED Blue Solid On: Unit Identied
LED2 Overheat/PWR Fail/Fan Fail LED
Red Solid On: Overheat
Red Blinking: PWR Fail or Fan Fail
LED3 BMC Heartbeat LED Green Blinking: BMC Normal
LED4 Power On LED Green Solid On: System is On/Running
Connector Description
AUDIO FP Audio Front panel Header
BT1 Onboard Battery
COM1/COM2 COM Headers
DP1/DP2 DisplayPorts (Version 1.3)
FAN1 ~ FAN4 System/CPU Fan Headers (FAN1: CPU Fan)
FANA, FANB I/O Fan Headers
IPMI_LAN Dedicated IPMI LAN Port
I-SATA0 ~ I-SATA3 Intel® PCH SATA 3.0 Ports
I-SGPIO1 Serial Link General Purpose I/O Header
J15 4-pin Connector for HDD (to provide power from the motherboard to onboard devices)
J18 Extended CMOS Battery Connector
JD1 Speaker/Buzzer Header (Pins 1-4: Speaker, Pins 3-4: Buzzer)
JF1 Front Panel Control Header
JGPIO1 General Purpose I/O Header
JIPMB1 4-pin BMC External I2C Header
JL1 Chassis Intrusion Header
JPI
2
C1 Power Supply SMBbus I
2
C Header
JPW1 24-pin ATX Power Connector
JPW2
8-pin 12V DC power for CPU (Required) or alternative power for special enclosure when the
24-pin ATX power is not in use
To Next Page
Loading...
