Supermicro X12SAE - Motherboard Features; CPU Support; Memory Support; Chipset Details

17
Chapter 1: Introduction
Motherboard Features
CPU
• Supports a single Intel Xeon W-1200 series, 10th Gen Core i9/i7/i5/i3 series processor with up to 10 cores and a thermal
design power (TDP) of up to 125W
Memory
• Up to 128GB of Unbu󰀨ered (UDIMM) ECC/non-ECC with speeds of up to 2933MHz (by CPU) in four 288-pin memory slots
DIMM Size
• Up to 128GB at 1.2V
Note 1: Memory capacity and frequency is CPU dependent.
Note 2: For the latest CPU/memory updates, please refer to our website at http://www.supermicro.com/products/
motherboard.
Chipset
• Intel PCH W480
Expansion Slots
• One (1) PCI Slot (PCI SLOT1)
• One (1) PCI-E 3.0 x4 Slot (PCH SLOT2)
• One (1) PCI-E 3.0 x1 Slot (PCH SLOT3, X12SAE only)
• Two (2) PCI-E 3.0 x8/x16 Slots (CPU SLOT4, CPU SLOT6: Supports Auto Switch)
• Two (2) M.2 PCI-E 3.0 x4 Sockets (Support M Key 2280 and 22110)
Network
• Intel Ethernet i225V (X12SAE)
• Intel Ethernet i225-LM (X12SCA-F)
• Intel Ethernet i219LM (for AMT/vPro)
• Realtek RTL8211F (Dedicated IPMI LAN Port, X12SCA-F only)
I/O Devices
• Serial (COM) Port • One (1) front accessible serial port header (COM1)
• SATA 3.0 • Four (4) SATA 3.0 ports at 6 Gb/s (I-SATA0~3 with RAID 0, 1, 5, 10)
• Video Port • One (1) DisplayPort 1.4 connection on the rear I/O panel
• One (1) HDMI 2.0a connection on the rear I/O panel
• One (1) DVI-D on the rear I/O panel
• One (1) VGA on the rear I/O panel (for IPMI, X12SCA-F only)
Peripheral Devices
• One (1) front accessible USB 2.0 header with two USB connections (USB0/1)
• Two (2) USB 3.2 Gen 1 ports on the rear I/O panel (USB2/3)
• One (1) front accessible USB 3.2 Gen 1 header with two USB connections (USB4/5)
• One (1) USB 3.2 Gen 2 port on the rear I/O panel (USB6, Type C)
• Three (3) USB 3.2 Gen 2 ports on the rear I/O panel (USB7/8/9, Type A)
• One (1) front accessible USB 3.2 Gen 2 20-pin connector with one USB connection (USB10)
Motherboard Features
Note: The table above is continued on the next page.