Appendix D: UEFI BIOS Recovery
131
Note: Do not interrupt this process until the BIOS ashing is complete.
8. When the UEFI Shell prompt appears, type fs# to change the device directory path. Go
to the directory that contains the BIOS package you extracted earlier from Step 6. Enter
ash.nsh BIOSname.### at the prompt to start the BIOS update process.
9. The screen above indicates that the BIOS update process is complete. When you see
the screen above, unplug the AC power cable from the power supply, clear CMOS, and
plug the AC power cable in the power supply again to power on the system.
10. Press <Del> to enter the BIOS Setup utility.
11. Press <F3> to load the default settings.
12. After loading the default settings, press <F4> to save the settings and exit the BIOS
Setup utility.
To Previous Page
Loading...
