29
Chapter 2: Installation
4. Remove the thin layer of protective lm from the heatsink. CPU overheating may occur if
the protective lm is not removed from the heatsink.
5. Place the heatsink on top of the CPU so that the four mounting holes on the heatsink
are aligned with those on the retention mechanism.
6. With a T30 bit torque driver set to a force of 8.0 in-lbf (0.904 N-m), tighten the screws.
3
4
5
6
7
8
9
1
0
1
1
IN-LBF
8.0
0.904
N-M
Screw
Screw
Screw
Motherboard
top side
To Next Page
Loading...
