Supermicro X13SCW-F - Unit Identifier Switch (UID-SW); UID Switch; UID LED

37
Chapter 2: Installation
+
X13SCW-F
REV:1.01
DESIGNED IN USA
BAR CODE
MAC CODE
IPMI CODE
BIOS LICENSE
JSXB1A JSXB1C
JSXB1B
JWD1
JPME2
JPL2
JPL1
JVRM1
JPG1
MH3
MH1
MH2
MH5
MH6
MH7
MH4
LEDPWR
LEDMCU1
LEDMCU2
LEDM1
JUIDB1
JTPM1
SRW4
SRW6
SRW7
SRW5
JPW2
JPFR2
JDBG5
JL1
FAN2
FAN6
FAN5
FAN3
FAN4
FAN1
JF1
JPI2C1
JPW1
JSATA1
JSXB2
JBT1
JNVME1
BT1
JSEN1
JIPMB1
J7
JDBG2
JBPNI2C1
(3.2(10 Gb))
USB8 (3.2(10 Gb))
CPU
SXB2:PCIe x4
SXB1B:PCIe x16
I-SATA0–7
M.2-P
M.2-C
M.2 NVME
M.2 NVME
1-2:ENABLE
JPG1:VGA
2-3:DISABLE
USB2/3
USB4/5
USB9/10(3.2)
COM2
PWR I2C
COM1
:TPM/PORT80
22110
2280
JBT1:CMOS CLEAR
IPMI_LAN
USB0/1
22110
2280
1-2:ENABLE JPL1:LAN1
2-3:DISABLE
USB6/7
1-2:RST
JWD1:Watch Dog 2-3:NMI
JPME2
1-2:Normal
2-3:ME MANUFACTURING MODE
DIMMA1
VGA
JF1
RST
ON
PWR
OH
FAIL
FF
PWR
2
NIC
NIC
PWR
HDD
LED
1
NMI
X
DIMMA2 DIMMB1 DIMMB2
LAN1LAN2
UID-LED
UID-SW
1-2:ENABLE JPL2:LAN2
2-3:DISABLE
JL1:CHASSIS INTRUSION
LE6
C266
BMC
JTPM1
1
2
1. UID Switch
2. UID LED
Unit Identier Switch (UID-SW): One button with two functions
A Unit Identier (UID) switch and two LED Indicators are located on the motherboard. The
UID switch is located next to the VGA port on the back panel.
UID Switch
Pin Denitions
Pin# Denition
1 GND
2 GND
3 Button In
4 Button In
UID LED
Pin Denitions
Color Status
Blue: On Unit Identied
Note: After pushing and holding the UID-SW for 12 seconds, all BMC settings includ-
ing username and password will revert back to the factory default. Only the network
settings and FRU are retained.
Function User Input Behavior LED Activity
UID LED Indicator
Push Once Turns on the UID LED UID LED turns solid blue
Push Again Turns o󰀨 the UID LED UID LED turns o󰀨
BMC Reset
Push and hold for 6 seconds BMC will do a cold boot BMC Hearbeat LED turns solid green
Push and hold for 12 seconds BMC will reset to factory default BMC Hearbeat LED turns solid green