Supermicro X13SCW-F - Bootup NumLock State; Wait For F1 If Error; INT19 Trap Response; Re-try Boot

Chapter 4: UEFI BIOS
69
Bootup NumLock State
Use this feature to set the Power-on state for the <Numlock> key. The options are On and O󰀨.
Wait For "F1" If Error
Select Enabled to force the system to wait until the <F1> key is pressed if an error occurs.
The options are Disabled and Enabled.
INT19 Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this feature
is set to Immediate, the ROM BIOS of the host adaptors will "capture" Interrupt 19 at bootup
immediately and allow the drives that are attached to these host adaptors to function as
bootable disks. If this feature is set to Postponed, the ROM BIOS of the host adaptors will not
capture Interrupt 19 immediately and allow the drive attached to these adaptors to function
as bootable devices at boot up. The options are Immediate and Postponed.
Re-try Boot
If this feature is enabled, the BIOS will automatically reboot the system from a specied boot
device after its initial boot failure. The options are Disabled and EFI Boot.
Power Conguration
Watch Dog Function
If this feature is enabled, the Watch Dog Timer will allow the system to reset or generate
NMI based on the JWD1 jumper on the motherboard when it is inactive for more than ve
minutes. The options are Disabled and Enabled.
Front USB Port(s) (Available when DCMS key is activated)
Select Enabled to allow the specic type of USB devices to be used in the front USB ports.
Select Enabled (Dynamic) to allow or disallow this particular type of USB device to be used
in the front USB ports without rebooting the system. The options are Enabled, Disabled, and
Enabled (Dynamic).
Rear USB Port(s) (Available when DCMS key is activated)
Select Enabled to allow the specic type of USB devices to be used in the rear USB ports.
Select Enabled (Dynamic) to allow or disallow this particular type of USB device to be used
in the rear USB ports without rebooting the system. The options are Enabled, Disabled, and
Enabled (Dynamic).
Restore on AC Power Loss
Use this feature to set the power state after a power outage. Select Power O󰀨 for the system
power to remain o󰀨 after a power loss. Select Power On for the system power to be turned
on after a power loss. Select Last State to allow the system to resume its last power state
before a power loss. The options are Stay O󰀨, Power On, and Last State.