Supermicro X13SCW-F - Stop Bits; Flow Control; VT-UTF8 Combo Key Support; Recorder Mode

Super X13SCW-F User's Manual
84
Stop Bits
A stop bit indicates the end of a serial data packet. Select 1 Stop Bit for standard serial
data communication. Select 2 Stop Bits if slower devices are used. The options are 1 and 2.
Flow Control
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by bu󰀨er overow. Send a "Stop" signal to stop sending data when the receiving bu󰀨er
is full. Send a "Start" signal to start sending data when the receiving bu󰀨er is empty. The
options are None and Hardware RTS/CTS.
VT-UTF8 Combo Key Support
Use this feature to enable VT-UTF8 Combination Key support for ANSI/VT100 terminals.
The options are Disabled and Enabled.
Recorder Mode
Use this feature to capture the data displayed on a terminal and send it as text messages
to a remote server. The options are Disabled and Enabled.
Resolution 100x31
Use this feature to enabled for extended terminal resolution support. The options are
Disabled and Enabled.
Putty KeyPad
This feature selects the settings for Function Keys and KeyPad used for Putty, which
is a terminal emulator designed for the Windows OS. The options are VT100, LINUX,
XTERMR6, SCO, ESCN, and VT400.
Legacy Console Redirection
Legacy Console Redirection Settings
Redirection COM Port
Use this feature to select the COM port used to display redirection of Legacy OS and
Legacy OPROM messages. The options are COM1 and COM2/SOL.
Resolution
Use this feature to select the number of rows and columns used in Console Redirection
for legacy OS support. The options are 80x24 and 80x25.