Supermicro X13SCW-F - Flow Control EMS; SATA And VROC Configuration; SATA Controller(s); SATA Mode Selection

Super X13SCW-F User's Manual
86
Flow Control EMS
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by bu󰀨er overow. Send a "Stop" signal to stop sending data when the receiving bu󰀨er
is full. Send a "Start" signal to start sending data when the receiving bu󰀨er is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xo󰀨.
The setting for each of these features is displayed:
• Data Bits EMS
• Parity EMS
• Stop Bits EMS
SATA And VROC Conguration
SATA And VROC Conguration
SATA Controller(s)
This feature enables SATA device(s). The options are Disabled and Enabled.
*If this feature is set to Enabled, the following features will become available for
conguration:
SATA Mode Selection
Use this feature select the SATA mode. Select AHCI to congure an sSATA drive specied
as an AHCI drive. The options are AHCI and Intel VROC SATA RAID.
SATA Interrupt Selection (Available when "SATA Mode Selection" is set to Intel
VROC SATA RAID)
Use this feature to select the interrupt that will be available to the operating system. The
options are MSI-x, MSI, and Legacy.
Support Aggressive Link Power Management
This feature enables the PCH to aggressively enter link power state. The options are Disabled
and Enabled.
Serial ATA Port 0-7 Hot Plug
This feature designates the specied port for hot plugging. Set the setting to Enabled for hot-
plugging support, which will allow you to replace a SATA disk drive without shutting down the
system. The options are Disabled and Enabled.