13. The apparatus shall not be exposed to dripping or splashing.
14. The mains plug is used as the disconnect device, the disconnect device shall remain readily
operable. If the electric cable is damaged, it must be replaced by the manufacturer, or by the
qualification persons, in order to avoid a danger.
2. PRECAUTIONS
Before using this unit, be sure to read the applicable items of the operating instructions and these
safety suggestions carefully.
Afterwards keep them handy for future reference.
Take special care to follow the warnings indicated on the unit itself as well as in the operating
instructions.
Safety
Power Source-The unit should be connected to power supply only of the type described in the
operating instructions or as marked on the unit.
Environment
1. Water and moisture do not use this unit near water.
For example, near a bathtub, wash bowl, swimming pool, or the like, Damp basements should
also be avoided.
2. Condensation-moisture may form on the lens in the following conditions.
Immediately after a heater has been turned on.
In a steamy or very humid room.
When the unit is suddenly moved from a cold environment to a warm one, if moisture forms
inside this unit, it may not operate properly, to correct this problem wait about one hour for the
moisture to evaporate.
3. Heat never use or place this unit near a heat source.
Do not leave it in an automobile exposed to direct sun light for a long time with the doors and
windows closed as this may deform the cabinet.
4. The apparatus shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on the apparatus.
5. Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
To Next Page