Supersonic V16 - Power ON; OFF; Sleep Mode

Operating
Power ON/ OFF/ Sleep mode
2. Before start cleaning, please remove all kinds of wires on the floor to avoid damage or other
accidents caused by winding the robot during the cleaning process.
3.
take the wire into the slot or hangon the wall to avoid winding the device or causing
circuit accidents.
1. The charging base is recommended to be placed on the open floor of a room with
a larger area and usually the most need to be cleaned.
When the robot is power on and not doing
cleaning,After 3 minutes, it will automatically
shut down and sleep, saving power.
In sleep mode, operate the remote
control “ ”twice to wake up the machine.
Sleep mode
10
1M
1M
1M
Push the power switch to “ I ”, Power on;
Push the power switch to “ 0 ”, Power off;
Power ON/ OFF
ON
OFF
Fully charge the robot.
4
3
Place the charging base against the wall,
reserve a space of more than 1 meter in
radius;