Supersonic V16 - Filter Cleaning; Water Tank and Mop

17
Install water tank and mop
Water tank and mop
Power off the main device first
Open the water tank plug, slowly inject
water and close the softrubber plug
Power off
Paste the dry mop on the water tank,
fasten the elastic band, and smooththe
mop with your hand.
Paste the mop
Soak the mop,then squeezed excess water.
Wet the mop
Fill the tank with water
Warning
Please remove the water tank before
start charging.
When using wet mop, please inject
water and clean the mop after cleaning.
When using a wet mop, be careful to
prevent water from flowing into the
main device,causing damage or other
accidents.
Install the water tank
Note:
1. The robot and the water tank are attached by magnets. When the robot is working without
water tank, the magnet at the bottom of of the robot can pick up iron scraps from the ground,
small metal objects such as screws and needles, keep the kids and pets safer at home.
2. Please clean the adsorbed on the magnet before start cleaning, maintaining the robot or
before installing the water tank.
3. Do not use the wet mop on the wooden floor and carpet to avoid damage to the wooden
floor or carpet.
Put the water tank flat on the ground, hold
the host to make the tail close to the water
tank, can be adsorbed tightly together;