6
Filling directly from tap:
1. Detach the Hand-Held Steamer by
releasing the Lock (11) by lifting it up.
(Illust.16)
2. Push Hand-Held Steamer Release tab
(12) up. (Illust. 17)
3. Remove Hand-Held Steamer from
Steamer Body by lifting upwards and
away from Steamer Body.
4. Press Water Tank Release Button down to
remove tank. (Illust. 18A & 18B)
Illust.16
Illust.17
Illust.18A
Illust.18B
Illust.19
Illust.20
5. Open rubber plug, then fill from tap.
(Illust. 19)
Close plug and wipe off any spilled
water. Block the valve hole on the
water tank with a finger to prevent
water from dripping from tank before
re-attaching to the Hand Held
Steamer body. (Illust. 20)
6. Re-attach the tank to
the Hand-held Steamer
body by sliding it into
the slots. (Illust. 21)
NOTE: Although the SteamTek3 uses tap water, in areas with
hard water, we recommend using distilled water for better
performance.
Illust.21
IMPORTANT!
MAKE SURE THAT THE COPPER BALL INSIDE THE WATER TANK IS ALWAYS SUBMERGED
IN WATER WHEN MOP IS BEING USED.
WARNING!
DO NOT ADD ANY CLEANING DETERGENTS, SOAPS, OR SCENTED PRODUCTS INTO THE
WATER RESERVOIR OF YOUR MOP! THIS WILL CAUSE UNSAFE OPERATION OF THE MOP
AND COULD DAMAGE THE UNIT.
To Next Page
Loading...