5
For Use on Hard Floor
Surfaces:
Put the Microfiber Pad (1) onto
the Mop Head (3). (Illust. 9), then
pull the toggle cord to secure it in
place. (Illust. 10).
NOTE: DO NOT use the Carpet
Glider (14) on hard floor
surfaces as it could cause
damage.
INSTRUCTIONS FOR USE:
Illust.9
Illust.10
Illust.11
Illust.13
Illust.15
Illust.14
Illust.12
For Use On Carpeting:
Place the Mop Head (3) with Microfiber Pad (1) in place over the
Carpet Glider (14). (Illust. 11 & 12).
NOTE: DO NOT use a pad which has any noticeable holes,
abrasions or that is otherwise damaged as streaking and
scratching of floor surfaces could occur.
NOTE: DO NOT OPERATE UNIT WITHOUT THE PAD IN PLACE
The Microfiber pads (1) are machine washable in warm water.
AIR DRY ONLY – DO NOT DRY IN MACHINE
DO NOT BLEACH
DO NOT USE FABRIC SOFTENER
To clean the SteamTek3 unit, simple wipe with a soft cloth.
Filling the Water Tank:
NOTE: BEFORE FILLING THE WATER TANK, MAKE SURE THAT
THE UNIT IS UNPLUGGED.
Filling with the Measuring Cup:
1. Open rubber plug on water tank (6). (Illust.13)
2. Fill the included measuring cup (5) to the MAX line
indicated on the measuring cup. (Illust. 14) FILL TO
MAX LEVEL INDICATED ON THE TANK. DO NOT
OVERFILL THE WATER TANK. (Illust.15)
To Next Page
Loading...