7
Illust.22
Illust.23
OPERATION:
1. Plug unit into a correctly grounded electrical outlet.
The Red Power Indicator Light (18) will light up indicating that the unit is connected.
2. Wait approximately 30 seconds for the Ready To Use Indicator Light (20) to turn GREEN
indicating that the mop is ready for use.
NOTE: DO NOT press the ON/OFF Trigger (16) until the Indicator Light (20) is green in
case any residual water from previous use has remained in the unit. This water will
not be heated and will be forced out which could cause water pooling and puddling.
3. Press and hold the Mop Trigger (16) to release steam. Steam will be emitted as long as the
trigger is pressed. (Illust. 22) To stop emitting steam, release
the trigger. (Illust. 23)
4. Slowly pass the mop over the area you wish to clean.
NOTE: For best results, sweep or vacuum floor prior to using
the SteamTek3 Mop. To avoid water pooling/puddling, the
mirofiber pad (1) must be clean and dry before use.
CAUTION: To sanitize an area, leave the mop over the area for
a minimum of 8 seconds and a maximum of 15 seconds.
DO NOT leave the mop in a stationary position for longer than
15 seconds as this could cause a build-up of pale residue. If
this happens, the residue can be removed by using a
decalcifying product or with a few drops of vinegar.
NOTE: Use a cloth to wipe off residue build-up. Do not use
the mop.
5. Your SteamTek3 Mop will emit steam for approx. 20 minutes.
When it stops emitting steam, unplug the unit, remove the
water tank (or fill with cup), refill, replace tank, plug unit in, and
resume cleaning.
CAUTION: NEVER USE THE STEAMTEK 3 MOP WITHOUT
WATER!
6. When finished cleaning, unplug unit from outlet (by holding the
plug and not by the power cord), empty the water tank, REMOVE THE PAD FROM THE MOP
HEAD CAREFULLY AS THE PAD MAY STILL BE VERY HOT, wind the power cord around the
Cord Holder (15) and store it upright in a cool, dry area or by the Carrying Handle/Hook (17).
IMPORTANT!
• DO NOT STEAM ONE AREA FOR OVER 15 SECONDS AS THIS COULD RESULT IN FLOOR
SURFACE DAMAGE.
• During initial use, it may take several seconds for the SteamTek3 Mop to emit steam as the
water needs to flow through the filter to reach the heater. This will only occur the first time
you use your unit.
• When unit is filled with water the first time, you may hear a grinding sound indicating that
the pump is warming up. This will stop when the Green Indicator Light (20) lights up
indicating that the unit is ready for use.
To Next Page
Loading...