(The fine adjustment distance is 0.1mm) by Chunk buttons to let
the V gauge at the deep of V grove.
NOTE: this step is very important and make sure it is correct.
12. Press Re-edging button to see if the gauge is in the deepest of V
grove
13.Press STOP button to save it.
14. Adjust the V gauge on the right side of the V wheel by pressing
the button of moving left or right, usually it is on left side.
15. Press STOP button to save it.
16. Turn off the machine.
Remark: if the second pointed edge V wheel is encountered, the
correction method shall be the same as that of the first sharp
edge V wheel.
To Next Page
Loading...
