RMK-700 Operating Manual
Then, polish each part of the equipment.
(3) As polishing the parts of lens or glass, get rid of dusts on the surface of
lens with wind-blower and use a dry cloth.
3.4 Moving attention
(4) Turn OFF the power switch.
(5) Disconnect the power cable.
(6) Close the stage holding dial in the clockwise direction.
(7) Move this machine holding the lower part of the mains to keep
horizontally.
(8) Put it on the horizontal table
3.5 Service Information
(1) Repair:
If the problem is not solved in spite of the settlement according to
the contents of chapter Four, please contact agent with the information on
the following items.
● Name of Equipment Type： RMK-700
● Typical No. of Equipment : Typical number consisted of 8 digits and
characters written on its name plate
● Explanation on its symptom : Description in details
(2) Supply of parts required for repair:
The preservation period of parts required for repair of this machine is by
eight (8) years after stopping to produce the product.
(3) Disposal of the instrument:
Parts below are consumable in their characteristics, or the quality of them
shall de degraded after the long time use. User should not replace them by
him or herself. Please contact agent for the replacement if these parts are
consumed enough or degraded by the long time use. Back-up battery for clerk
and data
(4) Environment Protection
When disposing packing materials, sort them by the materials and follow local
governing ordinances and recycling plans.
4 Fault phenomenon and eliminating
To Next Page
Loading...