4
Safety instructions
Caution
Installation
Do not install the product under direct sunlight or UV light.
•
This may result in product damage, malfunction, discoloration, or deformation.
Do not install the power supply cable in a location where people pass by.
•
This may result in injury or product damage.
Do not install the product near magnetic objects, such as a magnet, TV, monitor (especially CRT), or speaker.
•
The product may malfunction.
Do not seal around the product with silicone, etc. when installing it on the wall.
•
The product may malfunction.
Keep the minimum distance between products when installing multiple products.
•
The product may be affected by radio frequencies emitted by other products and the product may malfunction.
Use the IEC/EN 62368-1 approved power adaptor that supports higher power consumption than the product.
It is highly recommended to use the power adaptor sold by Suprema.
•
If the right power supply is not used, the product may malfunction.
Use a separate power supply for the Secure I/O 2, electric lock, and the product.
•
If connecting and using the same power supply, the product may malfunction.
Operation
Do not drop the product or cause impacts to the product.
•
The product may malfunction.
Do not disconnect the power supply while upgrading the firmware of the product.
•
The product may malfunction.
Do not disclose the password to others and change it regularly.
•
This may result in illegal intrusion.
Do not press buttons on the product by force or do not press them with a sharp tool.
•
The product may malfunction.
Do not store your product in very hot or very cold places. It is recommended to use your product at
temperatures from -20 °C to 50 °C (BLN2-PAB: -10°C to 50°C).
•
The product may malfunction.
When cleaning the product, mind the following.
•
Wipe the product with a clean and dry towel.
•
If you need to sanitize the product, moisten the cloth or the wipe with a proper amount of rubbing alcohol and gently
clean all exposed surfaces including fingerprint sensor. Use rubbing alcohol (containing 70% Isopropyl alcohol) and a
clean, non-abrasive cloth like lens wipe.
•
Do not apply liquid directly to the surface of the product.
Do not use the product for anything other than its intended use.
•
The product may malfunction.
To Next Page
