Why does SUPREME 1200T Industrial Equipment processor take more horsepower than it did when new?
If the processor requires more horsepower than when it was new, the knives may be worn. Check and replace dull knives, as they can act as a brake, requiring more horsepower.
Why does it take longer to cut my dry forage now with SUPREME Industrial Equipment, than when the processor was new?
If it takes longer to cut dry forage than when the processor was new, the knives may be worn. Check and replace dull knives, as dull knives will lengthen cutting time.
What to do if hay floats on top of mix in SUPREME 1200T Industrial Equipment?
If hay floats on top of the mix, several factors could be the cause. First, ensure that you load dry light commodities first. Second, the bale may not be processed enough before adding other commodities; process dry commodities long enough to ensure the core comes apart. Finally, check the restrictor plates and set them to position #1 if they are in too far.
What to do if hay boils over top of tub in SUPREME 1200T Industrial Equipment?
If the hay boils over the top of the tub, it could be due to the unit being overloaded; decrease the volume of dry roughage. Also, check the yellow restrictor plates on the tub. Restrictor plates that are in too far can cause lighter commodities to rise up in the tub instead of falling down to the bottom. Set restrictor plates into position #1.
What to do if forage lengths are too long in SUPREME 1200T?
If the forage lengths are too long, set the restrictor plate to position #1. Also, increase the RPM (VFD only), make sure dry forage is added first, let forage process longer before adding other commodities, and add one or more extra knive(s).
What to do if there is a dead spot in the tub of SUPREME 1200T?
If there's a dead spot in the tub where feed moves slower or not at all, check the leading edge of the auger for wear. A worn edge will not pull feed from the tub wall, causing feed to hang up in spots. Also, check the kicker plate for wear; a worn-off kicker plate will not direct feed into the auger, slowing down mixing.
How to fix uneven mix in SUPREME 1200T?
If you have an uneven mix, run the unit a little longer to ensure sufficient mixing time. Additionally, check the restrictor plates and set them to position #1 if they are in too far.
What to do if forage lengths are too short in SUPREME 1200T?
If the forage lengths are too short, it may be due to over-processing of the forage; try faster loading of commodities. Alternatively, decrease the RPM (VFD only) or remove knife #4 and/or #3 from the auger.
How to break up and process hard core bale in SUPREME 1200T?
If you have a hard core bale that is difficult to break up and process due to tightly wound, coarse roughage, add an extended backing plate to position #6 or #7 on the augers to decrease processing time.
Details the limited one-year parts and labor warranty for Supreme International processors.
Extended warranty for major drive components against defects.
Specific terms and conditions that nullify or affect warranty coverage.
Primary methods to call attention to potential hazards and precautions.
Safety precautions and guidelines for operating the feed processor.
Warnings for crush, flying object, alcohol/drug, and piercing hazards.
Information and placement of safety labels and decals on the machine.
Recommended steps for sequential loading and mixing ingredients.
How to adjust mix consistency by changing parameters.
Critical wear components on the auger and their maintenance.
Procedures for gearbox maintenance and oil changes.
Procedures for changing planetary oil for various models.
Troubleshooting common issues during the cutting and mixing phases.
Guide for correct bolt tightening torque specifications.
General| Brand | SUPREME |
|---|---|
| Model | 1200T |
| Category | Industrial Equipment |
| Language | English |
To Next Page
