Why does SUPREME 900T Industrial Equipment processor take more horsepower than it did when new?
If the processor requires more horsepower than when it was new, the knives may be worn. Check and replace dull knives, as they can act as a brake, requiring more horsepower.
Why does it take longer to cut my dry forage now with SUPREME 900T, than when the processor was new?
If it takes longer to cut dry forage than when the processor was new, the knives may be worn. Check and replace dull knives, as dull knives will lengthen cutting time.
What to do if hay floats on top of mix in SUPREME 900T Industrial Equipment?
If hay floats on top of the mix, several factors could be the cause. First, ensure that you load dry light commodities first. Second, the bale may not be processed enough before adding other commodities; process dry commodities long enough to ensure the core comes apart. Finally, check the restrictor plates and set them to position #1 if they are in too far.
What to do if hay boils over top of tub in SUPREME Industrial Equipment?
If the hay boils over the top of the tub, it could be due to the unit being overloaded; decrease the volume of dry roughage. Also, check the yellow restrictor plates on the tub. Restrictor plates that are in too far can cause lighter commodities to rise up in the tub instead of falling down to the bottom. Set restrictor plates into position #1.
What to do if forage lengths are too long in SUPREME 900T?
If the forage lengths are too long, set the restrictor plate to position #1. Also, increase the RPM (VFD only), make sure dry forage is added first, let forage process longer before adding other commodities, and add one or more extra knive(s).
What to do if there is a dead spot in the tub of SUPREME 900T?
If there's a dead spot in the tub where feed moves slower or not at all, check the leading edge of the auger for wear. A worn edge will not pull feed from the tub wall, causing feed to hang up in spots. Also, check the kicker plate for wear; a worn-off kicker plate will not direct feed into the auger, slowing down mixing.
How to fix uneven mix in SUPREME Industrial Equipment?
If you have an uneven mix, run the unit a little longer to ensure sufficient mixing time. Additionally, check the restrictor plates and set them to position #1 if they are in too far.
What to do if forage lengths are too short in SUPREME 900T Industrial Equipment?
If the forage lengths are too short, it may be due to over-processing of the forage; try faster loading of commodities. Alternatively, decrease the RPM (VFD only) or remove knife #4 and/or #3 from the auger.
How to break up and process hard core bale in SUPREME 900T Industrial Equipment?
If you have a hard core bale that is difficult to break up and process due to tightly wound, coarse roughage, add an extended backing plate to position #6 or #7 on the augers to decrease processing time.
Replaces Executive Summary paragraph detailing contract commencement date and duration.
Adds requirement for delineating the Prime Contractor Area as shown in the attached figure.
Modifies the contract start date and period of performance as specified in Schedule A.
Adds a new requirement for sanding operational areas for safe vehicle and equipment movement.
Replaces the existing figure in Appendix D with a new version (Attachment No. B).
Notes the inclusion of the Supreme International Mechanical Stationary Operator's Manual for reference.
General| Brand | SUPREME |
|---|---|
| Model | 900T |
| Category | Industrial Equipment |
| Language | English |
To Next Page
