Mechanical Stationary
Operator’s Manual
© 05/2020 300-0804
13
SAFETY
ROTATING DRIVELINE
CONTACT CAN CAUSE DEATH
KEEP AWAY
DO NOT OPERATE WITHOUT -
• ALL DRIVELINE GUARDS, TRACTOR AND
EQUIPMENT SHIELDS IN PLACE
• DRIVELINES SECURELY ATTACHED AT BOTH ENDS
• DIVELINE GUARDS THAT TURN FREELY ON
DRIVELINE
DO NOT USE PTO ADAPTERS
SP101
DANGER
Safety Labels and Decals
The safety labels and decals are attached to the feed
processor. They must be checked regularly.
• Make sure anyone who operates the feed processor
understands all the information, warning, caution and
danger safety decals.
• Keep all the decals clean so they are readable. Do not
cover up or obstruct any of the decals from view.
• Make sure all the safety decals are installed and in
good condition.
• Replace any missing or unreadable safety decals.
• Do not operate the feed processor until the decals are
replaced.
• When replacing decals make sure the surface is clean
and dry. Use a clean cloth to remove any trapped
air bubbles from under the decal for good adhesion.
Decals should be applied in temperatures of 50°F
(10°C) or warmer.
Figure 2
Figure 3
PART NUMBER SIGNAL WORD DESCRIPTION
SP-12 CAUTION
Read and understand Operator’s Manual before using. Keep riders off the
machine. Stop engine, place all controls in neutral, set park brake, remove
ignition key and wait for all moving parts to stop before servicing, adjust-
ing, maintaining, or unplugging. Do not adjust machine while in motion.
Use care when working around a high pressure hydraulic system. Keep all
components tight and in good repair. Be sure all safety devices and shields
are in place before starting operation. Keep hands, feet, hair and clothing
away from moving parts.
SP-13 DANGER
Rotating auger. Keep hands, feet, hair and clothing away from rotating
auger. Do not grab twine or objects when auger is in motion. Keep others
away.
SP-20 WARNING Keep hands, feet and clothing away from moving parts.
SP-21 DANGER Keep children away at all times.
SP-23 CAUTION
Before welding. Shutdown and disconnect feed processor from tractor
of pull type models. Shutdown engine and remove key on truck models.
Disconnect junction box lead-in cable from scale. Disconnect the power
supply from scale indicator. Disconnect the positive battery cable. Ground
welder close to work. Never draw current through weigh bars. See owner’s
manual.
SP-101 DANGER
Rotating Driveline. Contact can cause death! Keep Away! Do not operate
without all driveline guards, tractor and equipment shields in place, drive-
lines securely attached at both ends and driveline guards that turn freely on
driveline.
Table 1. Safety Labels
To Next Page
Loading...
Need help?
General
