Mechanical Stationary
Operator’s Manual
© 05/2020 300-0804
11
SAFETY
WARNING
Do not operate this equipment until you have
carefully read and understand the safety and
operation procedures in this manual and all other
equipment manufacturers’ manuals that will be used
with it.
Do not allow inexperienced or unqualified personnel
to operate the feed processor. Have a thorough
understanding of the equipment before operating.
Keep all bystanders, children and pets away while
in operation. Always use common sense while
operating the feed processor.
Read and Understand Procedures
Supreme International cannot anticipate every possible
circumstance that might involve a potential hazard. You
must satisfy yourself that a technique is safe for you
and others. You should also ensure that the equipment
will not be damaged or made unsafe by the operation or
maintenance procedures you perform.
Follow all applicable federal, state, local and industry-
Safety Precautions
Improper practices and carelessness can cause personal
injury or even death.
The following safety precautions and guidelines must be
throughout this manual and labeled on the feed processor.
To ensure your safety, the safety of others and the safe
operation of the feed processor, read, follow and practice
the following:
WARNING
The safety precautions that follow have WARNING
level hazards.
Exposure Hazard
ALWAYS wear the appropriate personal protective
equipment as required by the task at hand, including
but not limited to:
• Relatively tight and belted clothing
• Safety gloves
• Safety shoes/boots
• Safety glasses/goggles/shields
• Hearing protection, ear plugs
• Head protection, hard hats
ALWAYS read and comply with safety labels on all
chemical containers.
Entanglement / Sever Hazard
• NEVER wear jewelry, watches, unbuttoned
cuffs, ties or loose fitting clothing and ALWAYS
tie long hair back when working near moving/
rotating parts.
• Never reach into the tub to clean twine, feed,
debris or any other object when the feed
processor is in operation.
• ALWAYS keep hands, feet, hair and clothing
away from all moving/rotating parts.
• NEVER operate the feed processor without the
guards and safety shields in place.
• Never allow anyone to position themselves near
or at the top of the feed processor. The rotating
auger will cut or sever.
Entanglement Hazard
NEVER leave the key in the ignition switch
when you are servicing the machine.
Someone may accidentally start it and not
realize you are servicing it.
Sudden Movement Hazard
ALWAYS stop the engine before beginning
service.
To Next Page
Loading...
Need help?
General
