Mechanical Stationary
Operator’s Manual
© 05/2020 300-0804
9
INTRODUCTION
General Information
This manual is intended to be a permanent part of your Supreme Feed Processor and should remain so at all times. This
manual has been written and designed to provide you with safe operating and maintenance guidelines. Please familiarize
yourself with this manual to ensure years of safe and trouble-free use.
Model and Serial Number Location
The model and serial number of your Supreme Feed Processor are located on the identification plate. This plate is located
on the left hand front corner of the unit. Another plate is affixed to the cabinet with model, serial number and electrical
information. Please refer to this identification plate prior to parts and service inquiries.
Figure 1
Your Supreme Feed Processor
The operation of your Supreme Feed Processor varies greatly with climate conditions and various feed components.
There are basic rules and steps required to obtain the desired processed feed results. The operation of the Supreme
Feed Processor is very easy, provided a few basic, but important, instructions are followed.
A new machine will require an initial break-in period. Please refer to 22 of this manual for
proper break-in procedures. In addition to the procedures, a new machine may require several loads for the tub walls and
auger flighting to become polished. Until this is accomplished, you may experience spillage, uneven movement of feed,
increased horsepower draw or increase fuel consumption. Loads may have to be downsized until the unit is adequately
polished.
The Supreme Feed Processor is designed to quickly and efficiently process a wide variety of feedstuffs. By blending these
feedstuffs with other rationed components, you will be able to produce an unmatched quality of feed for your livestock.
It is important to remember that varying conditions and operations may require some experimentation with the procedures
described.
To Next Page
Loading...
Need help?
General
