Guide comb installation
Cleaning
Oil
Firstly align and secure the top of the guide
comb with the blade head, and then snap the
bottom of the guide comb into the bottom of the
blade head. When disassembling, firstly pull the
bottom of the guide comb apart, and then
remove the guide comb.
To maintain optimum performance,please clean
the clippers after each use.
1.Use the cleaning brush provided to clean any
residual hair from the blades;
2.Remove the guide comb, and clean them
under running water. Please ensure they are
thoroughly dry before storage or further use.
3.Oil the blades after each use to ensure
optimum cutting performance.
IMPORTANT: The blades must be cleaned and
oiled regularly to function properly, failure to
clean and oil the blades regularly will void the
warranty. The clippers are not whole body
waterproof, do not rinse the blades under
running water.
For better cutting performance, it is highly
recommended to keep the blade oiled after
each use.
1. Unscrew the cap of the oil bottle and cut off
the end of the plastic tube with scissors.
2. Remove the blade cover and turn on the
clipper.
3. Hold the clipper at a 45-degree angle,
squeeze the tubing lightly, and drip some
amount of the oil directly onto the blades.
4. Leave the clipper on for a few more seconds
to allow the oil to spread thoroughly along the
length of the blade.
5. Turn off the hair clipper and gently wipe with
a cloth to remove excess oil before use.
Important: It is recommended to replace the blade
head once a year for better cutting performance.
When working, the blue light is long-lighted; the
Red light starts flashing when 10% of the power
remains;
When charging, the red light is long-lighted; The
red light is off and the blue light is on when
charging is completed;
Blocking protection: It will automatically
shutdown at current 3A for 3 seconds; at this
time, you should immediately shut down the
clipper, and check the cause of the blocking;
Charging high-voltage protection: when the
input voltage is higher than 6.5V, it will stop
charging; please replace the charging plug with
an input voltage not higher than 6.5V.
Red and blue lights flash alternately when the
above protections are on.
3 4
To Next Page
Loading...