HOW TO REALIGN
THE BLADES?
After a 40-minute continuous use, it generally
heats up slightly. Please turn off the clipper and
restart it after it cools down. If the heat is
abnormally high, please stop using it
immediately and cool it down for a while before
restarting. If the heat persists, please contact
customer service via support@suprent.com.
1. The moving blade moves in a crying-face
curve, so it is normal if you find the blades are
a little bit not aligned.
2. Please realign the blades if you remove them
for cleaning or replacement. Here are the tips:
(1). Match the teeth of the fixed and moving
blades point for point. The end of the moving
blade teeth should be approximately 0.5-1.0mm
lower than the fixed blade.
(2). If the blades are not aligned, add a few
drops of oil to the blades. Turn the clippers on
for a few moments, then turn them off and
unplug them.
(3). Loosen the screws slightly and adjust the
blades until they are aligned.
(4). Tighten the screws to secure the blades in
place.
If you still have further issues, you are welcome
to contact After-sales support without
HOW TO REMOVE
AND REASSEMBLE
THE BLADES?
hesitation via support@suprent.com
If there is excessive noise, or you need to
replace the blades, please follow the below
steps:
Step 1. Turn off the hair clipper and adjust the
taper (see picture A).
Step 2. Disassemble the screws and the fixed
blade. Keep the screws.
Step 3. Disassemble the small moving blade on
the plastic shaker and replace it with a new one
(see picture B).
Step 4. Assemble and secure the fixed blade
with the screw lightly. Make sure that the end of
the moving blade teeth is about to 1/32" (1mm)
to 1/16" (1.5mm) lower than the end of the fixed
blade as shown in picture C and that the moving
blade is centered and parallel to the fixed
blade.
Warm Tips: The top edge of the fixed blade must
be at least 1/32" (1 mm) higher than the top edge
of the moving blade and as centered as
possible. This is important to prevent the
clippers from cutting too close or pinching the
skin. Be sure to add a few drops of oil to the
blades before running. Don't forget to tighten
5 6
To Next Page
Loading...