FOR THE UNIVERSAL
PROBLEM
packages and blisters to make a contribution to
environmental protection and sustainable
development.
Q1: It does not cut at all, but pulling hair;
A1: The blade is dull, please replace the blade
head regularly.
Q2: The blade is rusted;
A1: Please use the provided cleaning brush to
clean the remaining hair on the blade for daily
care, oil the blade after cleaning, and do not
rinse the blade under running water;
A2: It has been used for a long time, please
replace the blade head regularly to maintain
better cutting performance;
Q3: Get hurt while using the clippers?
A1: Do not forcefully cut the hair against the
skin, use it gently against the skin;
A2: When installing/adjusting the blade head,
Please make sure that the teeth of the moving
blade are about 1mm lower than the upper edge
of the fixed blade to avoid being scratched
during use;
Q4: It is unable to charge or when charging, the
screen display shows "EI" and keeps flashing;
A1: The input voltage of the adapter is too high,
please use a power adapter not higher than 5V
1A, and charge it with the included charging
cable;
Q5: It cannot be turned on after a period of time
use
A1: The clippers are not waterproof, please do
not wash the body under water;
A2: It may be hair stuck on the blade head,
which triggers the stall protection.Please
remove the blade head to clean the hair
referring to the blade assembly and disassem-
bly tutorial
Q6:The noise is very loud.
A1: Please confirm whether the screw is
tightened;
A2: If there is a lot of noise after using for a
period of time, it may be caused by hair stuck
on the blade head. Please remove the blade
head to clean the hair referring to the assembly
and disassembly tutorial;
Q7: The heat of the blade is abnormally high.
A1: Please follow the maintenance tutorial to
drip oil before use and after a period of use;
9 10
To Next Page
Loading...