HOW TO ADJUST THE
BLADE ON THE
HAIR TRIMMER
ADJUST TAPER
ECO-FRIENDLY
PACKAGE:
1. Use a screwdriver to unscrew the two small
screws on the fixed blade.
2. Adjust the distance between the moving and
fixed blade with your fingers until the moving
blade is flush with the fixed blade or slightly
below the fixed blade.
3. Make sure the blades are properly aligned.
The teeth of the moving blade should be slightly
below the top edge of the fixed blade ruler,
about 1 mm apart. If the blades are not aligned
correctly, you may cut or scratch your skin
when trimming.
4. Ensure that the moving blade does not
extend beyond the fixed blade. If the moving
blade extends beyond the fixed blade, you may
cut your skin.
5. After adjusting the blade to your preferred
position, gently tighten the two screws of the
fixed blade. If the blade is not adjusted to your
satisfaction after testing, please repeat the
adjustment process.
The tapered rod on the hair clipper can control
the length of the hairstyle. It can be adjusted
from 0.5mm-2mm.
How to adjust taper:
1. Slowly push the taper rod down to get a
longer hair length.
2. Push the taper rod up to get a shorter hair
length.
SUPRENT advocate being responsible for the
earth and society and hope that available
resources can be recycled to give value again
by professional treatment, thus preventing the
earth from waste heaping and environmental
pollution. Therefore SUPRENT uses secondary
recycled paper and soy-based inks on all of our
Longer Cut
Close Cut
9 10
To Next Page
Loading...