SL11B & S1500 Manual 934-6644 - Page 4
READ THIS
WARNING
FIRST!
The heater is designed and approved for use as a construction heater
under CAN 2.14-2000. The primary purpose of construction heaters
is to provide temporary heating of buildings under construction,
alteration, or repair and to provide temporary emergency heat.
Properly used the heater provides safe economical heating. Prod-
ucts of combustion are vented into the area being heated.
The heater is not designed as an Unvented Gas Fired Room Heater
under ANSI-Z21.11.2 and should not be used in the home.
ANSI A119.2(NFPA 501C)-1987 Recreational Vehicle Standard
prohibits the installation or storage of LP-Gas containers even
temporarily inside any recreational vehicle. The standard also prohib-
its the use of Unvented Heaters in such vehicles.
Gas inspection authorities in Canada require that the
installation and maintenance of heaters and accessories be
accomplished by qualified gas fitters.
Installation must comply with CAN/CGA-B149.2 Installation
Code for Propane Burning Equipment.
Installation must comply with CAN/CGA-B149.1 Installation
Code for Natural Gas Burning Equipment.
We cannot anticipate every use which may be made for our heaters.
CHECK WITH YOUR LOCAL FIRE SAFETY AUTHORITY IF YOU
HAVE QUESTIONS ABOUT LOCAL REGULATIONS.
Other standards govern the use of fuel gases and heat producing
products in specific applications. Your local authority can advise you
about these.
FOR YOUR SAFETY
DO NOT USE THIS HEATER IN A SPACE WHERE
GASOLINE OR OTHER LIQUIDS HAVING
FLAMMABLE VAPOURS ARE STORED OR USED.
To Next Page
Loading...