Surge master SE80CR - User Manual

Questions and Answers

A
aallenAug 1, 2025
Why does the cylinder rod move slowly or not move on my Surge master SE80CR?
- C
  Christopher LittleAug 1, 2025
  If the cylinder rod on your Surge master Log Splitter moves slowly or not at all, here are a few things to check: * First, ensure that the choke is off and the throttle is set to maximum, as low engine speed can cause this issue. * Also, check the hydraulic oil level and top it up if it's low. A plugged oil filter can also be the culprit, so consider changing it. * If wood is jammed around the wedge, shut off the machine and safely remove the wood. If these steps don't resolve the problem, the system relief setting may be low, and you should call a technician.
E
Emily ClayAug 9, 2025
What to do if the control handle doesn't go to neutral after the rod is fully retracted on Surge master SE80CR?
- K
  Kevin HenryAug 9, 2025
  If the control handle on your Surge master Log Splitter doesn't return to neutral after the rod is fully retracted, it might be due to several reasons. The hydraulic fluid might be too cold; allow the machine to warm up. Also, the hydraulic fluid might be too old or contaminated, in that case you should change the hydraulic fluid and filter. If the issue persists, the detent may be set too tight, requiring adjustment by a technician.
N
Nicole RosarioAug 16, 2025
Why does the control handle go to neutral before the rod is fully retracted on my Surge master SE80CR?
- J
  Joseph HortonAug 16, 2025
  If the control handle on your Surge master Log Splitter goes to neutral before the rod is fully retracted, the detent may be set too loose, requiring adjustment by a technician.
C
Christina BrownAug 25, 2025
How to stop the wedge from jumping on my Surge master SE80CR Log Splitter?
- T
  tanyakingAug 25, 2025
  If the wedge on your Surge master Log Splitter jumps, it could be due to the wedge frame jamming. Try lubricating the wedge frame wear plates.