Copyright SURVIVOR FILTER™ 2018
Survivor Filter PRO X
How to Use
Priming the Internal System
Priming the System Option #1:
Unscrew and remove the Ultra Filter/Carbon Filter
assembly and fill the chamber with clean water.
You can then reinsert the Ultra Filter/Carbon Filter
assembly and begin operating the PRO X.
Priming the System Option #2:
Fill the entire backwashing Syringe with clean water.
Attach syringe to the Water Inlet Fixture on the PRO X.
Push through water and allow water to flow out of the
Ultra Filter Water Outlet Tip. Ensure the Carbon Filter
and Ultra Filter are still installed in the unit during this
step. You are now ready to use the PRO X!
NOTE: If you intend to store your PRO X for more than 4
weeks, please also follow the steps for priming the internal
system before next use.
To avoid damaging the internal system and the pump
mechanism, ensure the Ultra Filter Pre-Filter is aached to
the hose before use. Do not allow dirty water go flow into
the PRO X without the Ultra Filter Pre-Filter.
Once connected to a power source, you will need to prime
the internal system with water before the first use.
To Next Page
Loading...