SUTPHEN TOWERS, INC. 2012
Manual-2012
_SL75-SA75-SP70.docx
Page 24 of 55
8/31/2012
RETRACT THE STABILIZERS
Remove jack pins.
Activate switch marked "Jack Release", located inside the hydraulic compartment.
Retract the stabilizers by depressing the “RAISE” switch, located near the control box. Release
the "Jack Release" switch and activate "Hi-Speed" switch on pump panel until jacks are fully
retracted.
Push the operator's step in and lock in place.
Turn the switches marked "Upper Power" and "Bucket Power" off.
Enter the cab and disengage the fire pump, if used.
1. Shift transmission to neutral.
2. Wait until speedometer registers "0" miles per hour.
3. Move pump shift lever from "pump" position to "road" position.
4. Disengage the PTO switch from "in" to "out" position. Make sure the red pilot light goes
out.
5. Release the parking brake.
6. Place transmission in appropriate gear (Drive 1-4 or Reverse).
Before driving away, the operator should make a quick inspection around the
truck to make sure all tools and appliances have been removed and stowed,
compartment doors closed, and the vehicle is unobstructed.
Operator must also check the four (4) warning lights above the windshield
marked "Upper Power", "Jacks Down", "Cab Door Open", and "Compartment
Open" to make sure they are not lighted.
All personnel must be seated and seat belts fastened before unit is moved.
Never back the truck unless a guide has been placed at the rear of the truck,
giving clear signals to the operator. If the guide disappears from view, the
movement must be stopped until the guide appears.
To Next Page
Loading...