Sutphen SL75 - Page 34

SUTPHEN TOWERS, INC. 2012
Manual-2012 _SL75-SA75-SP70.docx Page 34 of 55 8/31/2012
7. Connect or submerge the inlet
side of the suction hose to/into a
container of Dexron III hydraulic
fluid.
8. Lift the red safety cover over the
Hydraulic Tank Fill switch, and
move the switch to the up position.
9. Activate the Aux. Motor switch for
30 seconds. This will begin to draw
approximately ½ gallon fluid from
the container.
10. Check the fluid level in the
reservoir.
11. If the fluid level is below the
full level, repeat steps 9 and 10.
Adjusting the time period as
necessary. CAUTION: Do not
run the Aux. Motor for more than
10 minutes
12. When the fluid level reaches
the full level (approximately 2”
from the top); push the Hydraulic
Tank Fill switch red safety cover
down. This will turn the switch off.
13. Remove the suction hose
from the Hydraulic Tank Fill port,
and securely replace the rubber
plug.
14. Drain the remaining fluid in
the suction hose back into the
fluid source, and replace the metal
plug.
15. Return the cab to the stowed
position.