Sutron 8310 - Page 61

Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 61
verified by watching the display for a short period.
The Date and Time can also be set via command line, SSP and BASIC.
Station Setup
The Station Setup menu provides a way to perform most of the essential functions needed to set
up an 8310. A typical Station Setup menu is provided below:
Station Setup
Measurements (9) >
Basic >
Communications (4) >
Logs (2) >
Log Records (1) >
LAN Settings >
Users (0) >
Advanced Settings >
Read setup from file
Write setup to file
Clear setup
Save formatted setup
End Station Setup
The items in the station setup menu provide a means to set up the following submenus:
Measurements () >
The number in parenthesis is the number of measurements enabled. Press RIGHT or ENTER to
enter the measurements sub-menu. See Station Setup/Measurements for more information.
Basic >
Press RIGHT or ENTER to enter the Basic sub-menu. See Station Setup/Basic for more
information.
Communications () >
The number in parenthesis is the number of communications ports enabled. Press RIGHT or
ENTER to enter the communications sub-menu. See Station Setup/Communications for more
information.
Logs () >
The number in parenthesis is the number of log files on the flash disk. Press RIGHT or ENTER to
enter the log sub-menu. See Station Setup/Logs for more information.
Log Records () >
The number in parenthesis is the number of log records defined in the system. Press RIGHT or
ENTER to enter the log records sub-menu. See Station Setup/Log Records for more information.
LAN Settings >
LAN settings configure the Ethernet port. Press RIGHT or ENTER to enter the LAN settings sub-
menu. See Station Setup/LAN Settings for more information.