Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 62
Users () >
The number in parenthesis is the number of users defined in the system. Press RIGHT or ENTER
to enter the user’s sub-menu. See Station Setup/Users for more information.
Advanced Settings >
Advanced Settings contains settings for rarely used station settings. Press RIGHT or ENTER to
enter the log sub-menu. See Station Setup/Advanced Settings for more information.
Read setup from file
This function reads a setup from SD card or flash disk and makes it the current setup.
Write setup to file
This function writes the current setup to an SD card (or other location on the Flash Disk, if you
specify).
Clear setup
This function clears the current setup and sets all values back to default. It creates a blank slate
for starting a completely new setup. Note: this won’t change the kinds of communications
devices assigned on COM2 and COM3, but will reset the setup values associated with those
ports to their default state (e.g., clear dial-in and dial-out messages, etc.).
When clearing the setup remotely,
communication settings will reset to their
defaults for devices installed on COM2 and
COM3. If you are connected via one of these
ports, you may need to reconnect to the station
after clearing the setup!
Save formatted setup
This function prompts for a filename and then saves the current setup in a file formatted in such
a way to make it easy to read.
Station Setup/Measurements
Measurements (9)
M1*: TEMP > Sample 5 of 6
M2: VBAT > Next: 13:57:00
M3: VBAT_HR > Next: 14:00:00
M4*: AirTemp > Sample 4 of 6
M5: RelHumid > Next: 13:57:00
M6: Stage > Next: 13:57:00
M7*: DewPoint > Executing
M8: testdata > Next: 13:57:00
M9: Stage > Next: 14:00:00
Add Measurement
Delete Measurement
Copy Measurement
Move Measurement
End Measurements
To Next Page
Loading...
