14 DR-Z400SMK5 (’05-MODEL)
• Clamp the axle holder 2 with a vise. Protect the axle holder
surface using a rag.
• Loosen the center bolt 3 completely with a 21 mm socket
wrench.
• Compress the outer tube by hands and install the conrod
holder (special tool) between the axle holder bottom 2 and
locknut 4.
09910-20115: Conrod holder
• Hold the locknut with a wrench and remove the center bolt.
• Remove the push rod.
Clamping the axle holder too tight can damage it
which will affect riding stability.
Do not clamp the axle holder too tight.
SAMPLE
To Next Page
Loading...
