Leveling stand screw jack installation
1) Thread right side screw jack into threaded leveling stand hole on
bracket B and adjust leveling jack bolt out.
2) Push motorcycle over from left side until right screw jack is
touching floor.
3) Install left side screw jack on bracket A and adjust out until
motorcycle will rest upright on both screw jacks.
4) Adjust screw jacks until motorcycle is level.
CAUTION -Use screw jacks to hold motorcycle upright and level
ONL~ Do not lift motorcycle with screw jacks.
CAUTION- Use care when installing screwjacks. Be certain
that motorcycle is always in a stable balanced position.
To Next Page
Loading...
