LOWER UNIT 10-19
WATER PUMP ( Impeller & Case )
Place the under panel gasket 1 and under panel 2 in position.
Insert the key 3 in the driveshaft and slide the impeller 4 onto
driveshaft, ensuring that key and keyway are aligned.
Install the pump case 5 while rotating driveshaft clockwise to
flex the impeller vanes in the correct direction.
Securely tighten the four (4) pump case nuts to the specified
torque.
! Pump case nut : 8 N
.
m (0.8 kg
.
m, 5.8 lb.-ft.)
PROPELLER INSTALLATION
Apply Water Resistant Grease to the propeller shaft.
Install propeller stopper 1, propeller 2, spacer 3, washer 4
and nut 5 in turn.
Tighten the propeller nut to the specified torque.
M 99000-25160 : Water Resistant Grease
! Propeller nut : 18 N
.
m (1.8 kg
.
m 13.0 lb.-ft.)
Push cotter pin 6 through nut and shaft, then bend to secure.
M
!
To Next Page
Loading...
