23
4. Make sure that remote control handle is in
“NEUTRAL”.
5. Confirm the select LED lights, if not, depress
the select switch on the remote control box.
Depress the “THROTTLE ONLY” button.
6. Move the control handle forward until the
caution buzzer sounds one time.
7. Press the “UP” side of PTT switch three
times within three seconds. The buzzer will
sound one time briefly indicating the setting
has been accepted.
8. Return the throttle to the fully closed position
and install the lock plate on the emergency
switch. Operate the full tilt up and full down
operations several times by pressing the
PTT switch and check that the setting of the
tilt upper limit is properly set.
V
WARNING
Setting of the tilt upper limit position will not
prevent the outboard motor from tilting fully
up and contacting the motor well if the
motor’s lower unit hits an object at high
speed. Such tilting could damage your motor
and boat and injure the boat occupants.
Keep all occupants away from the motor when
operating at high speed.
MOTOR COVER FASTENING
ADJUSTMENT
If you feel motor cover fastening is loose or too
tight when locking the levers, adjust as follows:
1. Loosen the bolts 1, 2 and 3.
2. Adjust the position of brackets 4, 5 and 6.
To increase the fastening, move the brackets
to the direction A. To decrease the fasten-
ing, move the brackets to the direction B.
3. Tighten the bolts.
Motor cover
To Next Page
Loading...
