58
STARTING THE ENGINE
NOTE:
If the emergency stop switch lock plate is not in
position, the starter motor cannot operate.
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
2. If equipped with Keyless Start System:
(1)Confirm that the keyless fob is in communi-
cation ON mode (Refer to the “Switching the
Communication mode of the keyless fob”
section.) Check that the keyless fob is within
communication range with the keyless con-
trol unit.
(2)Quickly press the engine switch to set Key-
less Start System to ON state (buzzer
sounds once) and automatically start all
engines.
V
WARNING
Exhaust gas contains carbon monoxide, a
dangerous gas that is difficult to detect
because it is colorless and odorless. Breath-
ing carbon monoxide can cause death or
severe injury.
Never start the engine or let it run indoors or
where there is little or no ventilation.
(3)To start each engine individually, press and
hold the engine switch for at least 2 seconds
to set Keyless Start System to ON state
(buzzer sounds once). Then press the con-
trol panel start/stop switch to start each
engine individually.
If not equipped with Keyless Start System:
Turn until the ignition key is in the “ON” posi-
tion.
Turning the ignition key to the “START” posi-
tion automatically starts all engine.
After returning the ignition key to “ON” posi-
tion from “START” one, starter motor con-
tinue to turn for 4 seconds until engine start.
NOTICE
If you hold the ignition key at the “START”
position to start the engine, the starter system
can be damaged.
Turn the ignition key to the “START” position
once and release it to start the engine. The
engine will crank continuously for 4 seconds
or until the engine starts.
OFF
ON
START
To Next Page
Loading...
