60
If equipped with Keyless Start System:
EMERGENCY START
If the keyless fob cannot be used due to a dead
keyless fob battery or other issue, you can start
the engines without the keyless fob by entering
the passcode in the multi-function gauge.
Use the following procedure to start engines
without using keyless fob.
1. Pressing engine switch causes “Check Key-
less FOB” to appear on the screen. The
buzzer will be triggered with one long beep
followed by 3 short beeps.
2. “Enter Passcode?” appears when any button
in the gauge is pressed.
To enter the passcode, use the [ ] or [ ]
button and then select “Yes”. Then, press the
[SET] button to proceed to the “Enter Pass-
code” entry screen. (Selecting “NO” turns
the system off.)
3. Enter a 6-digit passcode.
Use the [ ] or [ ] buttons to select a num-
ber for each digit.
Press the [SET] button to move to the next
digit. Press the [MENU] button to return to
the previous digit.
4. If the entered digits matches the 6-digit
passcode, pressing the [SET] button will dis-
play the normal screen appears and starts
the engines.
The system returns to the screen from step
2 if the entered digits do not match the pass-
code. (Enter the passcode correctly.)
NOTE:
• If you select yes for [Enter Passcode?], you
must complete the entry within 5 minutes.
After 5 minutes, the power turns off.
• If the collation is NG, the "Enter Passcode?"
screen reappears.
• If you enter the wrong passcode 5 times in a
row, the keyless start system automatically
powers down the keyless start system and
does not accept a passcode for 30 seconds.
To Next Page
Loading...
