67
Example of the troll mode display on the Multi-
Function Gauge that can operate the troll
mode.
Example of the troll mode display on the Multi-
Function Gauge that cannot operate the troll
mode.
NOTE:
• This system will not function properly until
engine is at normal operating temperature.
• If the [MENU] button is pressed and held
while the remote control lever is in neutral,
the mode will not switch to TROLL Mode.
• For the multiple engines:
– If the throttle of all engines are fully closed
and one of engines is in-gear, it shifts to
the troll mode when the [MENU] button is
pressed.
– In-gear idle speed of all engines is con-
trolled at the same time.
When “No” is selected:
When “No” is selected and the [SET] button is
pressed, the display will return to the original
gauge screen.
Adjusting Trolling Speed
• When pressing the [ ] button, one short
beep sounds and the engine speed
increases by 50 r/min.
• When pressing the [ ] button, one short
beep sounds and the engine speed
decreases by 50 r/min.
To Next Page
Loading...
