47
6. Turn the air-vent screw on the fuel tank cap
clockwise to shut the vent.
REMOTE CONTROL MODEL
To stop the engine:
1. Shift into “NEUTRAL”.
2. After operating at full throttle, cool off the
engine a few minutes by allowing it to idle or
troll at low speed.
3. Turn the ignition key to the “OFF” position.
Always leave the ignition key in the “OFF”
position when the motor is not running, or
battery can discharge.
WARNING
If you leave the motor stopped for a long
period of time with the fuel line connected,
fuel can leak out.
Disconnect the fuel line, whenever you leave
the motor stopped for a long period of time.
NOTICE
If spilled gasoline is just left on painted sur-
face, it may cause a stain or discoloration of
the surface coating.
Wipe off any spilled gasoline immediately with
a soft cloth etc.
OFF
ON
START
4. After stopping the engine, disconnect the
fuel connector from outboard motor.
5. Turn the air-vent screw on the fuel tank cap
clockwise to shut the vent.
NOTE:
To make sure that the emergency stop switch
operates properly, stop the engine occasionally
by pulling out the lock plate, while operating the
engine at idling speed.
WARNING
If you leave the motor stopped for a long
period of time with the fuel line connected,
fuel can leak out.
Disconnect the fuel line, whenever you leave
the motor stopped for a long period of time.
NOTICE
If spilled gasoline is just left on painted sur-
face, it may cause a stain or discoloration of
the surface coating.
Wipe off any spilled gasoline immediately with
a soft cloth etc.
WARNING
Unauthorized use of your boat could lead to
an accident or damage to your boat.
To prevent unauthorized use of your boat, be
sure to remove the key and emergency stop
switch lock plate when the boat is unattended.
To Next Page
Loading...
