To Next Page
L
Laura WalkerSep 13, 2025
Why Suzuki Engine vibrates excessively?
- AAlexander HansenSep 13, 2025
Excessive vibration in your Suzuki Engine can be caused by: * A damaged propeller. * Loose engine mounting bolts or clamp screws.
Why Suzuki Engine vibrates excessively?
Excessive vibration in your Suzuki Engine can be caused by: * A damaged propeller. * Loose engine mounting bolts or clamp screws.
General| Engine Type | 4-Stroke DOHC 24-Valve |
|---|---|
| Steering | Remote |
| Starting System | Electric |
| Ignition System | Fully transistorized |
| Alternator | 12V 54A |
| Gear Ratio | 2.08:1 |
| Exhaust | Through Prop Hub Exhaust |
| Displacement | 4028 cc |
| Bore x Stroke | 98 x 89 mm |
| Maximum Output | 300 HP |
| Full Throttle Operating Range | 5, 700 - 6, 300 rpm |
| Fuel System | Sequential Multi Point Fuel Injection |
| No. of Cylinders | V6 |
| Oil Capacity | 8.0 L |
| Shaft Length | 20, 25, 30 inches |
| Recommended Fuel | 91 RON or higher |
| Recommended Engine Oil | SAE 10W-40 |
Explains the meaning of WARNING, CAUTION, NOTICE, and NOTE signal words used in the manual.
Provides important notices for owners regarding safety and manual usage.
Highlights hazards associated with battery acid, hydrogen gas, and sparks.
Explains system operation, communication range, and potential medical equipment interference.
Highlights dangers of battery ingestion and incorrect battery replacement.
Detailed steps for replacing the keyless fob battery, including O-ring care.
Warns about operating beyond maximum trim, risking injury and engine damage.
Explains how to display and change the Keyless Start System passcode.
Details the system that activates when engine speed exceeds limits.
Explains the system that warns of low oil pressure and reduces engine speed.
Details warnings for high oil temperature and engine overheating.
Describes the alert for a thermostat that fails to reach proper operating temperature.
Explains the system activated by battery voltage deficiency and its implications.
Warns of low battery voltage for keyless fob and control unit, affecting performance.
Explains cautions for engine stalling and alerts for water in the fuel system.
Lists essential checks before boating for safety and proper preparation.
Details the importance of checking engine oil level before each trip.
Provides detailed steps for checking and filling engine oil, including gasket usage.
Outlines procedures for the 10-hour break-in period to ensure engine longevity.
Describes starting engines using keyless start system or ignition switch.
Outlines essential pre-start checks and proper use of the emergency stop switch.
Details startup procedures for both keyless and ignition key systems.
Emphasizes engine warm-up and checking cooling water discharge.
Describes how to start the engine using a passcode if the keyless fob is unusable.
Explains emergency engine stop and how to shut down the keyless start system.
Provides a schedule of maintenance tasks based on operating hours or months.
Highlights dangers of improper maintenance and recommends authorized service.
Provides steps for changing engine oil, emphasizing warm engine and proper oil level.
Details the process of draining old engine oil and filling with new oil.
Explains how to check gear oil level and procedures for changing gear oil.
Provides detailed steps for flushing water passages using an engine flush device.
Outlines immediate actions and warnings for a motor accidentally submerged in water.
Details steps for motor storage, including oil changes, fuel stabilization, and warnings.
Covers battery storage and procedures for preparing the motor after storage.
Lists common causes and solutions for starter motor and engine start failures.
Addresses common issues causing unstable idling or engine stalling.
Details fuse identification, inspection, replacement, and related warnings.
