Suzuki DF70A - Transom Dimensions; Establishing the Center-Line

6
TRANSOM DIMENSIONS
ESTABLISHING THE CENTER-LINE
To establish the center of the transom you may use the following
procedure:
(1) Measure across the transom from chine to chine and make
a mark on the transom face at 1/2 of this measurement.
(2) Measure across the transom from strake to strake and
make a second mark on the transom face at 1/2 of this
measurement.
(3) Align a straightedge with the marks on the transom face
and draw a line. This is the vertical center-line of the tran-
som for a single engine installation.
(4) Drill mounting holes as in a single engine installation.
DF70A/80A/90A
38 (1.5)251 (10)
70 (2.8)
51 (2.0)
13.5 (0.53)
17.5 (0.69) 4-places
327 (12.9)
360 (14.2)
203 (8.0)
5 – 13.5
φ
Unit: mm (in)
Transom top surface
Chine
1/2 1/2
1/2
1/2
Strake