ELECTRICAL SYSTEM 6-3
CONNECTING BATTERY
•When disconnecting terminals from the battery for disassembly
or servicing, be sure to disconnect the negative - terminal
first,
•When connecting terminals to the battery, be sureto connect
the positive + terminal first.
•If the terminal is found corroded, remove the battery, pour
warm water over it and clean with a wire brush.
•Upon completion of connection, apply grease lightly.
•Put a cover over the positive + terminal.
WIRING PROCEDURE
•Route the wire harness properly according to “WIRE HAR-
NESS ROUTING” (Refer to page 7-10).
ADJUSTUSING POCKET TESTER
•Be sure to use positive + and negative - probes of the tester
properly. Their false use may cause damage in the tester.
•If the voltage and current values are not known, start measur-
ing in the higher range.
•before measuring the resistance and after changing the resis-
tance range, always perform O Ω adjustment.
•Taking a measurement where voltage is applied in the resis-
tance range may cause damage in the tester. When measur-
ing resistance, check to make sure that no voltage is applied
there.
•After using the tester, turn the switch to the OFF position.
A
To Next Page
