Suzuki GP125 - Page 66

45
OIL PUMP
AIR BLEEDING
Whenever evidence is noted of some air having
leaked into the oil pipe from the oil tank in a
machine brought in for servicing, or if the oil
pump has to be removed for servicing, be sure to
carry out an air bleeding operation with the oil
pump in place before returning the machine to
the user.
To bleed the air, hold the machine in standstill
condition. Loosen the screw (Т. to let out the air
and after making sure that the trapped air has all
been bled, tighten the screw good and hard.
CHECKING OIL PUMP
Use the special tool, to check the pump for ca
pacity by measuring the amount of oil the pump
draws during the specified interval
The checking procedure follows:
* Have the tool filled with SUZUKI CCI or CCI
SUPER OIL and connect it to the suction side
of the pump.
* Run the engine at 2 000 r/min.
е Holding engine speed at the same 2 000
r/min., move the lever up to the fully open
position (2) and let the pump draw for 2 min
uties. For this operation, the reading taken on
the device should be from 1.30 — 1.60 ml
(0.044/0.046 — 0.054/0.056 US/Imp oz)
09900-21602
CC! oil gauge
Гоп discharge 11.30 — 1.60 mi (0.044/0.046 — |
| amount 0.054/0.056 US/Imp oz)
|
NOTE
XE
E
Adjust
both
throttle
and
oil
pump
control
|
cable
play
after
checking
oil
pump.
*
Il анарны ан лиот -5