6-42
9. Draw out the axle shaft.
10. Slide the front wheel forward.
11. Put the new wheel in place and
insert the axle shaft.
12. Remove the jack and service
stand.
13. Hold the shaft and tighten the nut
5 to the specified torque.
14. Tighten the axle holder bolts 6 to
the specified torque.
15. Move the steering up and down
several times to seat the axle
shaft.
16. Tighten the axle holder bolts 7 to
the specified torque.
17. Reinstall the brake calipers and
speed sensor (GSX-R1000A).
18. After installing the wheel, apply
the brake several times to restore
the proper lever stroke.
NOTICE
Improper jacking may cause dam-
age to the fairing or oil filter.
Do not place the jack under the
lower part of the fairing or the oil
filter when jacking up the motorcy-
cle.
To Next Page
Loading...
