GENUINE SUZUKI ACCESSORIES
10/17
6. Reinstall the existing handlebar
balancer that was removed step
1.
Installation of Grip Heater Switch
1. Install the Switch Bracket 3 to
the Grip Heater Switch 2 by
using the two Screws 7.
2. Fix the Grip Heater Switch 2
assembly with the left rear view
mirror.
3. Pass the Grip Heater Switch 2
lead wire under the handlebar.
WARNING
Use the designated grip
cement, and dry well the
applied part, then check if it is
securely adhered.
If the cement other than those
designated is used, or drying
is not enough, there would be
a risk of the grip slipping off
during the riding. Verify that
the grip is securely mounted to
the handlebars before operat-
ing the vehicle.
Left rear
view mirror
To Next Page
Loading...
