Suzuki GSX-S1000 - Page 6

GENUINE SUZUKI ACCESSORIES
6/17
4. Apply thinly grease to the han-
dlebar.
5. Apply grease to the end of the
throttle cables and cable pulley.

99000-25011:
SUZUKI SUPER GREASE
“A” or equivalent
6. Insert the Grip Heater (R) 5
into the handlebar. Then, install
the throttle cable No.1 first, then
No.2.
7. Set the stopper peg of the
switch box to the hole in the
handlebar and tighten screws.
NOTE: After tightening screws of
the switch box, check to
make sure that the switch
box does not rattle.
8. Reinstall the existing handlebar
balancer that was removed step
1.
9. Adjust the cable play:
1) Loosen the lock-nut.
2) Turn the adjuster so that the
throttle grip has 2.0 – 4.0
mm (0.079 – 0.157 in) play.
3) Tighten the lock-nut.
4) Reinstall the boot.
WARNING
Check for smooth opening
and closing operations of the
throttle. See if there is any
catch in the throttle operation.
FWD
Switch box
Throttle cable No.1
Throttle cable No.2
Hole
Hole
Stopper
peg
Grip Heater (R)
BootBoot
Lock-nutLock-nut
AdjusterAdjuster